Cannot open /dev/ukbd0 during install
-
Hi
I am trying to install v2 RC1 on a Dell PowerEdge R210. During the boot process of the Live installer I get "cannot open /dev/ukbd0" and the machine hangs.
This server was previously running v.1.2.3Have tried swapping keyboards but still no luck.
Any suggestions?
thanks
Gordon -
Hi Gob…
My similar problem.
With older config don't appear.
1 config : R310 + 1 dual port intel gigabit + perc h 200 with snapshot of June 14 2011 and destination disk : cruzer blade usb pendrive - this work but onboard broadcom disabled2 config : R310 + perc6ir onboard and destination disk : raid1 with perc - tis don't work
My think is “dell Perc 6ir”
The freebsd 8.2 hardware support is very bad !!!
Now try with perc h700... -
Gob,,
I have a lot of R210 running Pfsense.
It's happen for me a few times before also setup hang at 38% on some of them
.
It can be bios version, bios setting or even something on the drive.
If you have another R210 give it a try on other hardware and it will probably work.
After that you can move the drive to this machine.
Keep us posted.Good luck.
-
Thank you David…but..
Latest Bios is installed
Bios Setting ? Parameter ?
Drive is clean... -
Ok, update !
Now my R310 work perfectly with 2.0 RC1 and update to the latest snapshot.My simple workaround :
Open Bios setting and disable all onboard Nics (and remove any pci ethernet card)
Boot with pfsense cd and install this perfectly.
Shutdown, reactivate any nic and reboot.
All works !
The Issue is caused by ethernet nic configuration.
Please send a feedback !