Load balancing and failover in pfsense 2.0 RC3
-
Then try to search the forum.
"multiwan" and "LoadBalancing" could help you. "routing group" will help you, too. -
Check the board here for 2.0. It's in a sticky post there, and all over the forum.
-
No…still did not found any solution. first of all i want to tell you that I am able to browse with single wan1 link that was configured at the time of installation of pf sense. but when I attached another wan2 link, browsing stopped. even removing of default wan1 connection browsing does not start. I am also attaching some screen shot of my pfsense configuration. Please help.
1st image is of my dash board
-
2nd screen shot is of my dns server configuration in general setup
-
screen shots of system gateway and system gateway groups
-
screen shots of firewall rules in floating and lan
-
screen shots of status gateways and gateway groups
-
screen shots of my squid guard proxy configuration
-
I am not familar with squid and load balancing on one machine.
Is LoadBalancing working if you use it WITHOUT squid installed ?
Without squid you do NOT need floating rules, just the LAN rule you added. -
actually I did not check it without squid in 2.0 but it was not working in 1.2.3 :(
-
i checked without squid…it is not working in pfsense 2.0 rc3 also ???
-
can you show us your OPT1 interface options ?
-
sure here it is…both opt1 and wan
