Help.. RC3 Upgrade failed. How do I recover?
-
Hi all,
I just upgraded this morning from RC2 (not sure which build) to the June 27th release of RC3. On reboot, I get the following error:
Configuring firewall.. Segmentation fault (core dumped)
At this point, I can not even ping the LAN interface from my management workstation (let alone access the webgui).
What are my options for recovery at this point?
Thanks,
Jeff
-
Well, after a reboot I can ping the LAN IP address. If I restart the webconfigurator from the console, I can then access the webgui. The config looks OK. But, I have no connectivity to the Internet. I tried backing up the config and restoring it. But, same result on reboot. I'm going to try installing an older firmware and see what happens.
-
Well, I couldn't get the firmware re-installed no matter what way I tried. So it looks like a re-install…. I should have known better to attempt an upgrade when I was scheduled to go production today...
-
FYI:
I was able to reset to default via the console and get back running. However, I had 2 different backup config files. (One from a week prior to the upgrade and one from after the failed upgrade). When restoring the config from after the failed upgrade, I got the same results. When restoring the original config, I did not receive any errors, but I had no Internet connectivity. I ended up redoing the config from scratch and it seems to be working now.
-
Do you still have the broken configuration files? (Before and after the upgrade)
If so, e-mail them to me - jimp (a) pfsense {dot} org
I'd like to look them over to see if there might be a problem somewhere in the upgrade code.
-
jimp,
Email sent…
Thx