Clarification on upgrading from 1.2.3 to 2.0 RC3 on alix board setup
-
Is the only upgrade path on alix boards to just burn the new image to a CF and physically swap it with the 1.2.3 CF card then restore the config. I looked at the upgrade guide but it wasn't clear to me what the upgrade paths are for embedded alix boards.
Can someone clarify?
-
From 1.2.3 to 2.0 on NanoBSD you can upgrade normally. Either via the manual GUI update or a console update by URL. The only option that will not work from 1.2.3 to 2.0 is auto update.
-
I have the same question. So if I understand well to upgrade from 1.2.3 on a CF Card with an 4g-nanobsd image, I just need to use the pfSense-Full-Update-2.0-RELEASE-i386.tgz file ? or should I use the pfSense-2.0-RELEASE-4g-i386-nanobsd-upgrade.img.gz file ?
Thanks for the clarification !
Nicolas -
pfSense-2.0-RELEASE-4g-i386-nanobsd-upgrade.img.gz
You always need to use the upgrade image that matches what you used to install.
-
Ok, clear now.
Thanks a lot for your prompt answer !
