WAN –>PfSense --> 2 vlan
-
I got PfSense 2.0RC3, three NIC, one from my ISP (WAN Rl0), one lan re0 static ip 192.168.0.1/24. The last NIC ale0 got 192.168.1.1/24 as static ip. Both are in the same subnet, 255.255.255.0. In the firewall i added a rule on the ale0 card so the internet works. I now want the computers on re0 and ale0 to see each other. I got one server on 192.168.0.* witch the computers on 192.168.1.* needs to reach.
–>LAN1 192.168.0.1
ISP -->PfSense
-->LAN2 192.168.1.1Is that possible? Do I have to add a new rule in the firewall? Any settings in DHCP?
Sorry for my english -
you need to add a rule on LAN and OPT1 to allow traffic from LAN –> OPT1 and from OPT1 --> LAN
no special settings are required for dhcp. If you want pfsense to hand out address' then you just need to fill in the start and end address'
-
DHCP is activated on both cards, 192.168.0./24 on LAN and 192.168.1./24 on the other.
Rule on LAN
Source: LAN subnet Destination: OPT1 subnetRule on OPT1
Source: OPT1 Subnet Destination: LAN SubnetPorts and protocoll is set to any.
This doesent work, or shoult I have some other settings? -
that should work ….
you can't ping any address' ??
you are sure clients on both ends have the correct gateway filled in ?
check firewall logs for any blocks that are relevant
-
timeout when Im trying to ping :-
The log only shows wan, nothing from lan. Any setting for this? I used Status–>system logs-->FirewallGateway on LAN is 192.168.0.1
Gateway on OPT1 is 192.168.1.1The same adress as the interfaces have. Should they have the same gateway?
-
that should be all okay …
provide some screenshot's of your firewall rules / interface pages so we can figure out what is wrong
-
It work now! It was the windows firewall on the computers with windows7. The server with w2003 and the xp machine worked, i tested on them and then the light went up, its windows again;) Thanks for all the help!:D