Which Version To Install - Read the versions page, need clarification.
-
I've put together a system for PFSense that will utilize a 30GB mSATA SSD Drive but I am unclear on which is the best version for this use.
I've read that perhaps "flashing" the drive with an embedded version is a wiser idea than simply installing it to this drive from lets say an ISO.
Can someone provide a little more clarity on which version would be the most correct version to use? This appliance will thrown against a network with no less than 300 active ports, with 30+ VLans and a 35Mbps Fiber internet connection
Additionally, what is the maximum number of interfaces PFSense can utilize?
Thank you in advance.
-
If you plan to add 3rd party packages (snort, squid etc) you probably want to install the full version i.e. pfSense-2.0-RELEASE-i386.iso.gz rather than the embedded.
-
but another hand, if you're afraid of hdd wearing out, then nano is better solution.
-
If you plan to add 3rd party packages (snort, squid etc) you probably want to install the full version i.e. pfSense-2.0-RELEASE-i386.iso.gz rather than the embedded.
I am not sure any of these will be required, do the nano versions not support these plugins?
but another hand, if you're afraid of hdd wearing out, then nano is better solution.
how heavily is the drive utilized with the full version vs. the Nano Version?
Thanks again for you replies.
-
i think that squid is quite heavy addon for the disk
-
but another hand, if you're afraid of hdd wearing out, then nano is better solution.
how heavily is the drive utilized with the full version vs. the Nano Version?
Thanks again for you replies.
In nano, the whole system is loaded into RAM and run from there with writes to the disk only happening when configuration is saved.