Unbound can't start after snapshot update (new thread!)
-
Finally committed support for IPv6 acls :P I have also updated the package to latest Unbound version 1.4.13. So give it a couple of hours while the package builder is building the new port.
-
Sweet! Can remove them from my custom options section, which is how I have been adding them now.
See it listed already, installing now
Looks like you forgot a _ in the allow_snoop
php: /unbound_acls.php: The command '/usr/local/sbin/unbound-control start' returned exit code '1', the output was '/usr/local/etc/unbound/unbound.conf:67: error: unknown keyword 'snoop' /usr/local/etc/unbound/unbound.conf:68: error: unknown keyword 'snoop' /usr/local/etc/unbound/unbound.conf:69: error: unknown keyword 'snoop' /usr/local/etc/unbound/unbound.conf:70: error: unknown keyword 'snoop' read /usr/local/etc/unbound/unbound.conf failed: 4 errors in configuration file [1317328224] unbound[30144:0] fatal error: Could not read config file: /usr/local/etc/unbound/unbound.conf'
So I have an ACL that allows snoop, but in the .conf file its put in as "allow snoop" which killed my unbound now it can not start. Trying to manually edit the ubound.conf now so I can get unbound to start.
-
Cool let me know if you get any problems.
-
just edited my last post – looks like a problem ;)
-
bah! and i did test that specifically. hang 5.
-
ok changed to allow vs allow snoop and looks good
from conf file
#allow
access-control: 192.168.1.0/24 allow
access-control: 10.0.200.0/24 allow
access-control: 127.0.0.0/8 allow
access-control: 2001:470:1f11:b85:0:0:0:0/64 allowchanged it to allow snoop in dropdown and get this.
access-control: 192.168.1.0/24 allow snoop
access-control: 10.0.200.0/24 allow snoop
access-control: 127.0.0.0/8 allow snoop
access-control: 2001:470:1f11:b85:0:0:0:0/64 allow snoopmissing the _ looks like to me.
-
Yeah 100% correct - fixed. So just update.
-
Sweet thanks!! Looks like same build number, just reinstall or will you be pushing say 1.4.13_01
-
Nah same build number - I didnt increase the version number for this change.
-
looks good now, thanks!
