Static route problem
-
I deleted your identical post from another thread you hijacked. Please keep discussion of one problem in one thread, and do not hijack existing unrelated threads.
-
Thanks,
But i use this setting and problem persist.
i am going to send images of my configuration to find the problem.
Regards
Nicanor
-
Please review my configurations images:
-
-
Please re-read my earlier post, especially the part in bold.
-
About ?
without a gateway set on the firewall rule
I was used without a gateway before i changed according Policy Route Negation instruction.
Regards,
Nicanor
-
Your rules passing to that gateway have the gateway set on the firewall rule, exactly what it says not to do. You do not set gateways on firewall rules for static routes.
That is for multi-wan gateway selection, not static routes.
-
Ok understood,
But i used before without gateway set on rules and same problem, i have multiwan configured and also static routes in secondary site, i have same scenery in 1.2.2 and no problem, what is wrong ?
Regards
Nicanor
-
1.2.x didn't show static route gateways in the firewall rule options.
I'm not sure what you had setup there but it wasn't doing what you thought it was.
-
I resume…
Principal site is not multiwan and have static routes pfsense 2.X ...
Secondary site is multiwan and have static routes pfsense 2.x
third site not multiwan only one LAN for 2 years and no problems, since 3 month i added multiwan an multilan same box same version with no changes and no traffic problems.
I think multiwan an multilan configurations affects rules for static routes ?
have any tool to monitor rules traffic for specific ip through static routes to find cause of block or transmission stop ?
Thanks for your help
Regards
Nicanor Martinez
-
Jimpp
Comercial support can analize and solve my problems ?
Regards
Nicanor Martinez
-
Hello,
I recreating small environment with virtual box one pfsense acts as router and second pfsense acts as firewall and windows xp virtual machine inside inet, configuring static route and after testing i found same issue when uploading data through static routes.
-
Explanation.
Pfsense is router LAN is 192.168.1.0/24 route to 192.168.0.0/24 Lan ip is 192.168.1.1 wan ip is 192.168.0.114 all traffic to deferents subnets pass i disabled packer filtering on pfsense and configure and static route to principal firewall to reach secondary network
Pfsense1 is firewall wan is a public ip and LAN is local ip on inet network 192.168.1.2
When i try to upload a file via ftp traffic stop from network 192.168.1.0/24 to 192.168.0.0/24
if you want to test i can upload all virtual environment to one server.
Regards
Nicanor