TSO and LRO on Alix boards

[MaxPF]

On the Alix (3 NIC) board is it ok to enable TSO and LRO options under the Advanced Networking page?
The NIC driver use is VR, but I can't find anywhere if it supports TSO and LRO.

[jimp]

$ifconfig -m vr0
vr0: flags=8843 <up,broadcast,running,simplex,multicast>metric 0 mtu 1500
        options=8280b <rxcsum,txcsum,vlan_mtu,wol_ucast,wol_magic,linkstate>capabilities=8284b <rxcsum,txcsum,vlan_mtu,polling,wol_ucast,wol_magic,linkstate>ether 00:0d:b9:xx:xx:xx
        inet6 fe80::20d:b9ff:fe18:8aa0%vr0 prefixlen 64 scopeid 0x1 
        inet 192.168.x.x netmask 0xffffff00 broadcast 192.168.x.255
        nd6 options=3 <performnud,accept_rtadv>media: Ethernet autoselect (none)
        status: no carrier
        supported media:
                media autoselect
                media 100baseTX mediaopt full-duplex
                media 100baseTX
                media 10baseT/UTP mediaopt full-duplex
                media 10baseT/UTP
                media none</performnud,accept_rtadv></rxcsum,txcsum,vlan_mtu,polling,wol_ucast,wol_magic,linkstate></rxcsum,txcsum,vlan_mtu,wol_ucast,wol_magic,linkstate></up,broadcast,running,simplex,multicast>

No TSO or LRO, and you don't want them in most cases anyhow. TSO/LRO help more for the case when the system is a client, not a router.

[MaxPF]

Thank you for the clarification jimp