Accessing ADSL Modem?
-
I have tried following the documentation (http://doc.pfsense.org/index.php/Accessing_modem_from_inside_firewall), however I'm still having issues.
What I have done:
0. Set Modem (Draytek Vigor 120) management IP as 192.168.3.2/24
1. Created OPT1 interface, which uses the WAN interface. Set the IP as 192.168.3.1/24
2. Created Outbound NAT rule:
Source: 192.168.1.0/24
Destination: 192.168.3.0/24
Translation: 192.168.1.2What I hope to achieve is the ability to access my modem at 192.168.1.2 on my LAN (192.168.1.0/24 network).
Any help or guidance is much appreciated.
-
Hmm, seems I can access my modem through the 192.168.3.2 network - I thought NAT would have presented this on the configured 192.168.1.2 IP?
-
Try changing your Outbound NAT rule to:
Source: 192.168.1.0/24
Destination: * (ANY)
Translation: Interface Address
-
You should be able to just access 192.168.3.2 from your LAN systems (assuming you set the firewall rules correctly), but if you want it to work on 192.168.1.2, you need a virtual IP for that IP address on LAN (unless 192.168.1.2 is the IP address of the LAN interface). The proxy ARP virtual IP type should work fine here.
-
I was able to do this when I was running DD-WRT; basically needed to run the PPPoE and an IP on the same interface. I have never been able to get this to work on pfSense; when and if I need to get on the modem I just connect a computer to it.
