Multi LAN Problem with OPT1

sunch1ld

Hi

I am using pfsense 2.0.1

I have a LAN configured with

ip address 172.24.128.1 /16

opt1
configurate with

172.24.0.1/24

wan dhcp

In Firewall: NAT: Outbound
Interface Source Source Port Destination Destination Port NAT Address NAT Port Static Port Description
WAN 172.24.0.0/16 * * 500 * * YES Auto created rule for ISAKMP - LAN to WAN
WAN 172.24.0.0/16 * * * * * NO Auto created rule for LAN to WAN
WAN 172.24.0.0/16 * * * * * NO Auto created rule for LAN to WAN
WAN 172.24.0.0/24 * * 500 * * YES Auto created rule for ISAKMP - OPT1 to WAN
WAN 172.24.0.0/24 * * * * * NO Auto created rule for OPT1 to WAN

When i connect a client I can go in internet trough the wan when I connect a client to opt1 i can not reach internet

I can not understand where is the problem. How can I create multi lan correctly?

Thanks in andvance

heper

did you create a firewall rule on the opt1 tab to allow traffic FROM opt1-subnet TO any ?

clarknova

Your LAN and OPT1 networks overlap, which is a problem.

sunch1ld

In that configuration I have no problem.
I Would like to know how disable routing and enable only some port forwarding between between two interfaces.

It's possible?

clarknova

From your first post:

when I connect a client to opt1 i can not reach internet

I can not understand where is the problem. How can I create multi lan correctly?

And from your last post:

In that configuration I have no problem.

I'm not going to try to tell you that you have a problem or not, but you did say so at one point, even if you're backtracking now. In any case, your setup is technically flawed in that you have overlapping subnets on your router interfaces.

sunch1ld

I solved thanks only adding the rules to go to internet