Can't set monitoring address due to bug
-
When i removed, saved, then tried to put in a simple ip address i got this error message on the System: Gateways: Edit gateway page
The following input errors were detected:
The IPv6 monitor address '174.129.234.103' can not be used with a IPv4 gateway'.
2.1-BETA0 (amd64)
built on Sat Jun 9 09:38:55 EDT 2012
FreeBSD 8.3-RELEASE-p2I scanned this forum briefly to find some similar comment but for now i hope this is helpful and doesn't get me flamed by some admin. I used this product for an eternity now.
-
Is there a space involved?
i have not seen that message in a few weeks. Maybe a variable wrong in the code. Not sure.
Just to be sure. If you have any gateways defined you need to edit and save those and see if it voes away.
-
There is no space involved just x.x.x.x, i am very aware to check for excess chars in input feilds having experienced it before.
Bug still there, basically i have no way to change any settings or edit the gateway unless i remove the monitor ip now because it ALWAYs says there is an ipv6 address there and creates an error if i open the gateway editing section.
Thanks for your reply.Regards
Sangye -
Will need to investigate.
-
seems to happen only with static gateways.
https://redmine.pfsense.org/issues/2503 -
Just checked in another attempt, because we now know the address family (because we have a drop down) that makes this a lot easier to get right.