Rules for webgui doesnt seem to work across interfaces!

Guest

Hello
I use these settings for all of my network interfaces without LAN:http://blog.stefcho.eu/wp-content/uploads/2011/06/pfSense-2.0-RC1-Configure-Captive-Portal-for-Guests-FireWall-Rules-00.png

Lan 10.10.10.10 (got default setting from pfense install)
Guest1:10.10.10.20 (settings from the link)
Guest2:10.10.10.30 (settings from the link)

Why can I still access the webgui in one interface to another after I have used these settings?

Example im in the Guest1 interface, the rules are working and I cannot get to the webui with this adress:10.10.10.20 or 10.10.10.10 ok its working! But when im trying to access 10.10.10.30 i get full access what to do?

The same thing happens when im in Guest2 interface. I cannot access webgui with 10.10.10.30 or 10.10.10.10 but i can still access the webgui with 10.10.10.20.

Thanks

stephenw10

Because you haven't blocked it! ;)

Rather than adding lots of rules this is a good situation to use an alias.
Create a new alias, I called it LOCAL, add all your local subnets to it.
Then change your 'Block Web GUI' rule to:

Protocol: TCP
Source: Guests net
Destination: LOCAL
Port: 443

There are many ways of accomplishing this, as long as it's logically correct use whatever is most readable for yourself. Fewer rules take less cpu cycles to process.

Steve

Guest

ah Ok:p

I took a picture you posted in an older post and past it here:P

Why did you choose 192.168.0.0
If my lan: is 192.168.1.1
Guest1:192.168.2.1
Guest2:192.168.3.1
Server:192.168.4.1

Will i then use 192.168.0.0 as alias or will i use 192.168.1.0 or will I use all four:
192.168.1.1 and 192.168.2.1 192.168.3.1 and 192.168.4.1

And why have you used netmask 16? (192.168.0.0/16)

Thanks

aliases.jpg_thumb

stephenw10

@Bebopper:

Why did you choose 192.168.0.0

Because I'm lazy. :P

192.168.0.0/16 is a subnet including all of 192.168..
So it includes all of my local interface subnets. It also includes a load of address space I'm not using which is bad. A better way is to enter each subnet individually so that only your used space is in the alias but this is quicker and I'm lazy. ;)

Steve

Guest

hehe

Im sorry for my late answer I havent have time before know!

Thanks !!

Then I learned something new!