Problem with incoming traffic on second WAN interface
-
I have a setup with 2 WAN connections
WAN is the default gateway
OPT1 is the secondary WAN connection.Port 443 is Nat'd on both interfaces to the same ip address
I have an Interface group with both WAN and OPT1 setup with all my firewall rules set on there for incoming connectionsWhen I try to connect to WAN:443 it works fine when I try to connect to OPT1:443 it fails.
If I do a packet capture I can see traffic coming in on the OPT1 interface but no outgoing traffic.
However on the WAN interface I can see traffic going out with the OPT1 address stamped on it - this is obviously wrong but I have no idea how to fix it.Outbound NAT is currently set to automatic.
Any ideas?
-
I have a setup with 2 WAN connections
WAN is the default gateway
OPT1 is the secondary WAN connection.Port 443 is Nat'd on both interfaces to the same ip address
I have an Interface group with both WAN and OPT1 setup with all my firewall rules set on there for incoming connectionsWhen I try to connect to WAN:443 it works fine when I try to connect to OPT1:443 it fails.
If I do a packet capture I can see traffic coming in on the OPT1 interface but no outgoing traffic.
However on the WAN interface I can see traffic going out with the OPT1 address stamped on it - this is obviously wrong but I have no idea how to fix it.Outbound NAT is currently set to automatic.
Any ideas?
1. Add to your Local Server additional IP (IP1: 192.168.1.10 and add IP2:192.168.1.11)
2. Set to Advanced Outbound NAT
3. Add a rule for Source 192.168.1.11/32 (second Server IP) to use OPT1 as Translated adress
4. Move this rule above Auto created rule for LAN to WANDo NOT forget to set a NAT rule for OPT interface
Regards,
Andrej