SquidGuard CIDR ranges
-
Hi everyone, is there any chance to use CIDR ranges in target categories tab in squidguard?
I need to use CIDR ranges, but i don't know if there is a chance to use them…
Best regards.
-
Hi everyone, is there any chance to use CIDR ranges in target categories tab in squidguard?
I need to use CIDR ranges, but i don't know if there is a chance to use them…
No. This is not supported for Target - only for Source.
-
Thanks a lot dvserg :)
-
Suggestion:
If you connect to the target only with the IP address then you can perhaps do some "RegExp" for the IP range you would like to use.Lets say for subnet 80.10.10.0/24
try to use:^http://80\.10\.10\.[1-254]/
I am no RegEx expert so this is probably wrong but the idea behind that could perhaps help you.
-
Suggestion:
If you connect to the target only with the IP address then you can perhaps do some "RegExp" for the IP range you would like to use.Lets say for subnet 80.10.10.0/24
try to use:^http://80\.10\.10\.[1-254]/
I am no RegEx expert so this is probably wrong but the idea behind that could perhaps help you.
I'll try that. I'm asking this because i need to let users access a range of network expressed in CIDR, via SquidGuard target categories tab…
Thanks a lot Nachtfalke