Can't continue to boot/load
-
i have a Amd64 Athlon system unit in office and i install PfSense version 2.0.2 amd64…..........
the installation is smooth and i find no error yet.....but after the installation and the system was rebooted
I was stuck in this format:F1 pfSense
F6 PXE
Boot: F1
\That's all thank you!!!!
-
but after the installation and the system was rebooted
I was stuck in this format:F1 pfSense
F6 PXE
Boot: F1
\That's all thank you!!!!
This is a 2.1 feedback forum so this post should be moved.
PXE is the system trying to boot from Ethernet. You need to enter the BIOS and select the correct disk as the primary boot device.
-
Has nothing to do with the fact PXE is there.
some of this may be helpful
http://doc.pfsense.org/index.php/Boot_Troubleshootingor trying 2.1 as it may play nicer with your hardware.
-
This has happened to be before… loading the embedded image and expecting output on the monitor. Make sure you use a VGA image!
-
This has happened to be before… loading the embedded image and expecting output on the monitor. Make sure you use a VGA image!
Don't think that's the case here, that should show a F1/F2 prompt. That boot prompt is from a full install.