Port forwarding problems
-
I specified 192.168.1.1 for both Gateway and Local DNS and IT WORKED! So this NAT entry is solved.
How about the others?
-
lol you want your monies worth ;)
Again I'm going to guess it's a routing issue. What's the OS of the boxes running Sab?
-
lol you want your monies worth ;)
Again I'm going to guess it's a routing issue. What's the OS of the boxes running Sab?
Lol, sorry about that.
Nope, I already solved the SAB problems. I'm pertaining now to entry numbers 3 and 5.
-
Sorry I thought I'd already posted what I thought was wrong with the setup to cause 3 and 5
The packet arriving at the 192.168.103.3 interface has the originating IP address of the request ie the computer on the internet. So it responds back but because it's default route is via wan3 the reply goes back to the sender with a different public IP than the one the request was sent to and the remote PC rejects it because it is not expecting a response from that host.
Can't see a fix for it as the default route for wan3 must be out so all I can suggest is that you move the NAT over to the wan3 IP and come in that way. -
Sorry I thought I'd already posted what I thought was wrong with the setup to cause 3 and 5
The packet arriving at the 192.168.103.3 interface has the originating IP address of the request ie the computer on the internet. So it responds back but because it's default route is via wan3 the reply goes back to the sender with a different public IP than the one the request was sent to and the remote PC rejects it because it is not expecting a response from that host.
Can't see a fix for it as the default route for wan3 must be out so all I can suggest is that you move the NAT over to the wan3 IP and come in that way.Ah. How do you move the NAT over to the wan3 IP?
-
BUMP!
-
Does it have a fixed IP or is it dynamic?
-
Does it have a fixed IP or is it dynamic?
The wan3 router ip or the modem3 ip? Both of them have fixed IP anyway.
-
If it's a fixed public IP then just put the NAT on the public interface and add a rule to allow the traffic through to the internal IP. It's exactly the same as the ones you have already setup just on a different interface.
-
If it's a fixed public IP then just put the NAT on the public interface and add a rule to allow the traffic through to the internal IP. It's exactly the same as the ones you have already setup just on a different interface.
Ok, I'll try that. Thanks :)