ALIX flash install or web upgrade of 2.0 completes but no IP to connect to.

[beedsley]

I must be missing something simple, but if I install 2.0 fresh(or upgrade from 1.2.3) I don't see how to configure the LAN IP from Serial Console, all I get is this in the console:

PC Engines ALIX.2 v0.99h
640 KB Base Memory
261120 KB Extended Memory

01F0 Master 848A SanDisk SDCFJ-512
Phys C/H/S 993/16/63 Log C/H/S 993/16/63

BIOS setup:

9 9600 baud (2) 19200 baud (3) 38400 baud (5) 57600 baud (1) 115200 baud
C CHS mode (L) LBA mode (W) HDD wait (V) HDD slave (U) UDMA enable
(M) MFGPT workaround
(P) late PCI init
R Serial console enable
(E) PXE boot enable
(X) Xmodem upload
(Q) Quit

Save changes Y/N ?
Writing setup to flash… d    f¼@    PC Engines ALIX.2 v0.99h
640 KB Base Memory
261120 KB Extended Memory

01F0 Master 848A SanDisk SDCFJ-512
Phys C/H/S 993/16/63 Log C/H/S 993/16/63

1  FreeBSD
2  FreeBSD

Boot:  2
/boot.config: -h
Consoles: serial port
BIOS drive C: is disk0
BIOS 640kB/261120kB available memory

FreeBSD/i386 bootstrap loader, Revision 1.1
(root@FreeBSD_8.0_pfSense_2.0-AMD64.snaps.pfsense.org, Tue Sep 13 17:52:09 EDT 2011)
Loading /boot/defaults/loader.conf
/boot/kernel/kernel text=0x8663b0 data=0x3ff908+0xbe798 syms=[0x8+0xda178+0x8+0xc796a]

Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [/boot/kernel/kernel]…
CPU doesn't support long mode

Type '?' for a list of commands, 'help' for more detailed help.
OK ?
Available commands:
  heap            show heap usage
  reboot          reboot the system
  autoboot        boot automatically after a delay
  boot            boot a file or loaded kernel
  lsdev            list all devices
  more            show contents of a file
  read            read input from the terminal
  echo            echo arguments
  unset            unset a variable
  set              set a variable
  show            show variable(s)
  ?                list commands
  help            detailed help
  include          read commands from a file
  ls              list files
  lsmod            list loaded modules
  unload          unload all modules
  load_geli        load a geli key
  load            load a kernel or module
  bcachestat      get disk block cache stats
  pnpscan          scan for PnP devices
  smap            show BIOS SMAP
  boot-conf        load kernel and modules, then autoboot
  read-conf        read a configuration file
  enable-module    enable loading of a module
  disable-module  disable loading of a module
  toggle-module    toggle loading of a module
  show-module      show module load data
OK

[wallabybob]

You need to install an "i386" kit on an Alix. You are attempting to run an "amd64" kit which was built to run on a CPU supporting "64 bit" instructions. The CPU on the Alix doesn't have "64 bit" instructions.