Squidguard3 fails to install and gb nics are shown 100mbits only
-
Hi:
I tried to test 2.1 but encountering following problems:
1. Squidguard3 packages fails to install.
2. GB nics (bge and em) are shown only 100mbits only
3. Internet drops frequently in WAN which gets back after rebooting.
-
The first problem was solved after upgrading the firmware released on 20130619.
I tried to specify manually the speed and duplex in the interface settings to '1000T Base Full-Duplex', but the entire interface stopped responding.
ifconfig -m bge0
…..
supported media:
media autoselect mediaopt flowcontrol
media autoselect
media 1000baseT mediaopt full-duplex,master
media 1000baseT mediaopt full-duplex
media 1000baseT mediaopt master
media 1000baseT
media 100baseTX mediaopt full-duplex
media 100baseTX
media 10baseT/UTP mediaopt full-duplex
media 10baseT/UTP -
I have a dual em NIC.
I've set my LAN/WAN (under the advanced button) "Speed and duplex" settings to "Default (no preference, typically autoselect)".Pressing save in the WAN/LAN menu saves some changes regarding DHCPv4 vs. DHCPv6 in the overall config of pfSense, which helps when the interface goes down and backup (If i remember correctly).
So this should solve your WAN dropping and only getting back after a reboot. -
I have a dual em NIC.
I've set my LAN/WAN (under the advanced button) "Speed and duplex" settings to "Default (no preference, typically autoselect)".Yep, 'Default' was what was originally selected, I tried to change only when it didn't work. I defauted back and still no go!
Pressing save in the WAN/LAN menu saves some changes regarding DHCPv4 vs. DHCPv6 in the overall config of pfSense, which helps when the interface goes down and backup (If i remember correctly).
So this should solve your WAN dropping and only getting back after a reboot.I have no IPV6 enabled. I changed back to 'Defualt' and saved and rebooted, yet the internet keeps on dying (but WAN interface appears to be active).