SquidGuard Group ACL not applying; incorrect client IP address
-
Hello everyone,
After I reinstalled SquidGuard and set up Access Lists for certain IP addresses (my laptop and router*) after several reboots, I cannot access sites that I whitelisted in my Group ACLs for no apparent reason, and not only that, the client IP shows the pfSense LAN IP Address and not the client's IP address (ex: 10.0.0.2 - my laptop) and the group is set to default and not the Group ACL that I assigned for my laptop…Did I do something wrong, like miss several steps? I can access any other site that is not blocked without a problem, just can't access the sites that I have set up to be allowed in my Group ACL...
-
Is your client source is set correct !? Did you set any order pref!? Is your "Target Categories" set properly!
In your "Target Rules" under "Groups ACL" did you set your desired group to "white-list"? Is your "default access" at the bottom of the same is set to "allow"!?
Did you hit "save" bottom after all your configuration and then hit "apply" on general page of squid-guard!?
Try clearing your browser cache before checking!
-
Is your client source is set correct !? Did you set any order pref!? Is your "Target Categories" set properly!
In your "Target Rules" under "Groups ACL" did you set your desired group to "white-list"? Is your "default access" at the bottom of the same is set to "allow"!?
Did you hit "save" bottom after all your configuration and then hit "apply" on general page of squid-guard!?
Try clearing your browser cache before checking!
I knew I forgot to hit apply; it officially works. I double checked my configurations to see what the heck was going on; I forgot to add the LAN IP address in the whitelist.
Group ACL names and source IP addresses:
Ben: 10.0.0.1-10.0.0.4 (pfSense, my laptop, server, and FreeNAS)
Wireless Clients: 10.0.0.1 10.0.0.5 (pfSense; Wireless Router*)- not connected yet
The space in between the 10.0.0.1 and 10.0.0.5 represents a separate IP address.
Thanks for the info, man.
Edit: When I change my laptop's IP address from 10.0.0.2 to 10.0.0.5 with every setting as the same (subnet mask, gateway, DNS1, and DNS2), the group ACL doesn't go from Ben to Wireless Clients, just stays at Ben. What else did I do wrong? Must be pfSense 2.1-RC0-i386 has bugs in it; I'm going to install pfSense-2.0.3-AMD64