Lanner FW-7541D Install 2.0.1
-
Recently purchased a Netgate FW7541 that came with 2.0.3 installed. I'm trying to downgrade to 2.0.1. I'm using a new CF card. The system gets up to the boot options and goes to default boot, but then that's as far as it gets. I have read about changed the behavior of the Redirection After BIOS post per other forums, but none of the settings work. With it set to ALWAYS, the above happens. Set to anything else, nothing happens and appears on the console. Anybody have experience with this or any other Lanner systems?
Serial setting is 9600/8/N/1
TYIA
-
Use the Netgate firmware for the 7535 from here (It's not the 7541 but it's nearly identical, close enough):
http://www.netgate.com/firmware/2.0.1-RELEASE-rebrand/
Or if you have another FreeBSD or pfSense unit around, you can adjust the image file or disk manually…
http://doc.pfsense.org/index.php/Embedded_install_on_Netgate_Hamakua
