Problem with two lan networks and access to ap

[firefox]

The dhcp not working on the AP

I had access to everything was normal

After doing an upgrade from pfsense 2.0.3
To version 2.1  {I forgot to mention it in the first post and added it}

now I do not have access to the AP

[kejianshi]

Are there rules on both interfaces to pass any from any for any protocol?

[firefox]

I do not know
When I plugged the ap it just worked

I guess there was something automatically tuned

Maybe something deleted in upgrading

[kejianshi]

Check your firewall rules.  Makes sure you have rules on each interface to pass/allow traffic.

[firefox]

The only thing I can think of
It is the first line of the wifi interface
I'm pretty sure it was like the first line of the lan interface
But I do not remember

[kejianshi]

Can you post Diagnostics > ARP Table?

[firefox]

Of course

In the first line where registered address 192.168.0.1
Registered home.plex

It should be listed also in the last line where the registered address 192.168.2.1
Not?

[kejianshi]

What is 192.168.2.8?

[firefox]

This laptop computer
Connected to the wireless network

With it I check the wireless network is working
And have access to the management interface of the ap

[doktornotor]

Well, I would suggest to flush the traffic shaping down the drain for starters. Took too long to respond sounds like you've shaped something to almost 0.

[kejianshi]

So, DHCP works on wireless?
DHCP works on wired LAN?
You can access the AP web interface on wireless?

But not wired?

But internet works from either wired or wireless?

Is all that correct?

[firefox]

@kejianshi:

So, DHCP works on wireless?
DHCP works on wired LAN?
You can access the AP web interface on wireless?

But not wired?

But internet works from either wired or wireless?

Is all that correct?

Is all that correct? – yes

@doktornotor:

Well, I would suggest to flush the traffic shaping down the drain for starters.

what  traffic shaping ?

[doktornotor]

All that "$foo computer is limited to $bar MB download" stuff.

[firefox]

Do not know if it is related to
Before I upgraded to 2.1

Everything worked properly with all these laws

Furthermore there was no law on the computer from which I am trying to access the interface

[kejianshi]

I think doktornotor is right.  Traffic seems to be working and allowed for the most part on both interfaces.  All I can imagine is that your limiter is breaking the AP interface access.

[doktornotor]

Yeah, that may have well worked before but not after upgrade. (Also completely unclear what you've actually done there.) Simplify the configuration to barebones for troubleshooting!

[kejianshi]

And with that - I'll check back in after some sleep…  Alot of it.

[firefox]

@kejianshi:

And with that - I'll check back in after some sleep…  Alot of it.

Thank you both for your help

I will try to suspend the rules, or remove them and see if i have access

[stephenw10]

IPv4/IPv6 issue? I don't think v6 is enabled by default in release, not sure though.

Steve

[firefox]

@doktornotor:

Well, I would suggest to flush the traffic shaping down the drain for starters.

@kejianshi:

I think doktornotor is right.  Traffic seems to be working and allowed for the most part on both interfaces.  All I can imagine is that your limiter is breaking the AP interface access.

I tried without rules
I tried to freeze them
Or removing them
Still the same result

@stephenw10:

IPv4/IPv6 issue? I don't think v6 is enabled by default in release, not sure though.

Steve

Indeed ipv6 off
I tried to run it but it requires ipv6
How do I fill it