Alix 2d3 Load Balancer OPT1 interface
-
Hi All,
I have setup up an Alix 2d3 board to run Pfsense ver 2.1. I can connnect to the router via the LAN address. I would like to set up the router as a Load Balancer, so I nedd to be able to use the OPT1 interface as the second WAN. I am not seeing the OPT1 interface being repotted under interfaces. How do I enable the OPT1 interface to use as a second WAN?
-
Hey Cenriq,
Click on "Interfaces | (assign)". Hit the "+" sign at the bottom and it should add the vr2 (DMZ) interface. Let us know if you have any further questions.
Juice
-
Hey Juiceman,
Thanks for the response. I had at one point hit "assign" before but I did not see the "+" at the bottom to add an Interface. Thanks again for pointing that out.
Now let me see if I gan get the Load Balancing to work.
Brgds
-
Hi All,
I am just getting back to this router and just realized that I can no longer connect to the router. I am not getting an IP addtress. I am using the web interface. I don't have a serila cable to se what/s going on. This proble only started since I enabled the second WAN ro configured Load Balancing. Any ideas what could have happened? TIA.