ALIX 2d2 questions

stephenw10

Probably not but….
What bandwidth are you looking to push through the box?

Steve

jjandrob

@stephenw10:

Probably not but….
What bandwidth are you looking to push through the box?

Steve

Hi Steve,

the IPSec tunnel is only used for voip to voip calls (g729) and remote desktop.

The internet connection is a cable modem with average use of under 1mb/s

stephenw10

@jjandrob:

SSL off load / squid. I have a single public IP and want to hand off several services based on IP.

Please elaborate on this. I suspect the Alix will not be up to that task even if your WAN bandwidth is low. 1Mbps average is low but what is the peak?

Steve

Edit: Typo

vincom

imho just buy the 800mhz one, future proof as you never know what you might need down the road

jjandrob

@stephenw10:

@jjandrob:

SSL off load / squid. I have a single public IP and want to hand off several services based on IP.

Please elaborate on this. I suspect the Alix will not be up to that task even if your WAN bandwidth is low. 1Mbps average is low but what is the peak?

Steve

Edit: Typo

Hi Steve,

Looking to do reverse SSL i believe is the term. where pfsense handles all SSL traffic for my internal servers. I create mappings for ww1.domain.com –> 192.168.55.13 and ww2.domain.com --> 192.168.55.14

Hope this helps!

stephenw10

Ah, Ok. So pfSense doesn't do that out of the box. You need to install a reverse proxy server that reads host headers.
Also you need it to do SSL so I think that limits your choices further. Maybe Squid 3? :-\ I'm not sure you'd have to do more research.
I can tell you than an Alix box is not a good target for that. To reduce any further complexity you probably want to run a full install from a hard drive. I think you're looking at a significantly more powerful box.

Steve

jjandrob

@stephenw10:

Ah, Ok. So pfSense doesn't do that out of the box. You need to install a reverse proxy server that reads host headers.
Also you need it to do SSL so I think that limits your choices further. Maybe Squid 3? :-\ I'm not sure you'd have to do more research.
I can tell you than an Alix box is not a good target for that. To reduce any further complexity you probably want to run a full install from a hard drive. I think you're looking at a significantly more powerful box.

Steve

thanks steve. It was not doing squid, do you think it could handle the nat traffic, IPSEC, and asterisk?

Thanks!

stephenw10

The capabilities of the Alix box are modest but well documented. It can firewall/NAT ~85Mbps. It can push IPSec traffic 10-25Mbps depending on encryption type (it has onboard AES hardware). See, for example: http://store.netgate.com/Netgate-m1n1wall-2D3-2D13-Black-P216.aspx
and http://forum.pfsense.org/index.php?topic=14581.0
and indeed here:
https://doc.pfsense.org/index.php/Are_cryptographic_accelerators_supported#Benchmarks

Steve

jasonlitka

@jjandrob:

Do you think the ALIX 2d2 with the 500mhz processor can handle this or should i grab the new 800mhz version?

What 800MHz version?

jjandrob

@Jason:

@jjandrob:

Do you think the ALIX 2d2 with the 500mhz processor can handle this or should i grab the new 800mhz version?

What 800MHz version?

i suppose i miss took a model number in a quick reading as the CPU speed.

Thanks!