Pfsense on Asrock C2750D4I gives Kernel Panic
-
I have tried to install 2.1.X on this new board I got. It gives kernel panic's on all versions.
It looks like this in the boot:
ACPI APIC Table: <intel tiano ="" ="">panic: AP #1 (PHY# 2) failed!
cpuid = 0
KDB: enter: panic</intel > -
General consensus with the Avoton/Rangely boards is that pfSense 2.1 is too old, based on FreeBSD 8.3. Either run pfSense 2.1 under a bare metal hypervisor like ESXi, or pitch in and help test 2.2.
A few months ago I would have recommended ESXi, but 2.2 is coming along nicely now and is quite stable in my experience.
-
2.2 for the last few days has had some issues with ssh which give me a hard time.
ESF were (until they ran out of stock) shipping Rangely boxes with 2.1.X installed. I think they're using Supermicro hardware.
This looks likely to be a bad BIOS problem, check for an update. It could just be a catastrophically unsupported NIC issue! ;) What NIC do you have?
Edit: i210s I see. They should be supported by the igb driver in 2.1.1 or newer. Maybe just unsupported PHYs as the error shows.Steve
-
I am running 2.2 at the moment. But I have found problems with both SSH (which seems to be known issue) and then OpenVPN!
I do like running bleeding edge in a way, but I really want OpenVPN to work =)
// Markus
-
RE: 2.1.5
I am using Supermicro 5018A-FTN4 which is a octacore system as well and I had to update settings in bios.
Disable all ACPI funtions
and drop available CPU's to 4Magic! works now until 2.2 is ready for production
-
we ship pfSense 2.1.5 and don't have to disable any cores, or ACPI.
hint: you're doing it wrong. (bad magic!)