Firebox x550e
-
If your awdflash command included the /cc switch then that cleared the cmos.
Did you extract the img file from the gzip file?
Win32 disk imager does not do the extraction for you unlike physdiskwrite.Steve
-
I removed the gz, extension that may have been a bad idea but the flash seemed to work fine.
-
You have to actually extract it from the gzip file. ;) 7zip can do it.
http://www.7-zip.org/
After extraction the image will be the full size of the Nano partition, so 4GB if you're using that.Steve
-
after doing that I dont get the disk error anymore, now i just get the pci device listing scree with a flashing cursor at the bottom.
-
woops quick update, I let it sit like that for a bit and now it says BTX loader 1.00 BTX version is 1.02 and the cursor is just flashing at the bottom.
-
The baud rate for pfSense is, by default, 9600 whereas the bios is at 115200. Did you change you serial terminal?
Steve
-
yes i changed the serial terminal, but i am currently watching it on my vga dongle
-
Ah, Ok. How have you attached the VGA, via the board header?
It could be because the Nano images switch to using only the serial console after the bootloader so you won't see anything via vga.Steve
-
Yeah i have both vga and serial hooked up right now, i see the same thing on both
-
What are you using for a serial terminal?
I have noticed that some terminal emulators don't handle the baud rate change well. For instance you have the terminal set to 9600 and boot the box. Initially you get garbage because the POST output is at 115200 but then when the output changes to 9600 you just see the cursor moving but no actual text. At that poing if you close the terminal program and re-open it at 9600 you should start to see the correct output.Steve