M1n1wall black hits fatal trap
-
My Netgate m1n1wall 2d2 black hits the following fatal trap. Would appreciate any pointers in resolving this.
Thanks,
GT
Welcome to pfSense 2.0-RELEASE …
Creating symlinks......done.
External config loader 1.0 is now starting... ad0s3
Launching the init system... done.
Initializing............................ done.
Starting device manager (devd)...done.
Loading configuration......done.
Updating configuration...done.
Cleaning backup cache........done.
Setting up extended sysctls...done.
Setting timezone...done.
Starting Secure Shell Services...done.
Setting up polling defaults...done.
Setting up interfaces microcode...done.
Configuring LAGG interfaces...done.
Configuring VLAN interfaces...done.
Configuring QinQ intervr1: link state changed to DOWN
faces...done.
Configuring WAN interface...done.
Configuring LAN interface...vr0: link state changed to DOWN
done.
Configuring OPT1 interface...wlan0: changing name to 'ath0_wlan1'Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address = 0xffff
fault code = supervisor read, page not present
instruction pointer = 0x20:0xc0a0fd80
stack pointer = 0x28:0xe2e24bac
frame pointer = 0x28:0xe2e24bb8
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 0 (ath0 taskq)
trap number = 12
panic: page fault
cpuid = 0
Uptime: 38s
Cannot dump. Device not defined or unavailable.
Automatic reboot in 15 seconds - press a key on the console to abort
Rebooting...
Ù[{³]PYüÉÿ[ÿÛÙÙYûIøß}ÿ}û ùÁËKé/öIÍáÛRÐMZmÒirö[
1 FreeBSD
2 FreeBSD -
Probably a flaky wireless card/driver.
Pop the card out, reassign the interfaces, then see if it stays up.
-
Yes, that helped. Hope it stays that way. Thank you.