Locked out of webgui
-
I know its working as i get the beep at the end
-
This is probably a bad idea….
however...I notice that that board has 3 (Realtek RTL8111E) ports...
You wouldn't happen to have a computer handy with a couple of realtek NICs that will accept an msata?
-
Please install heat spreader as described in the prior section.
- Insert a boot device (SD card, mSATA SSD, USB stick, or PXE through LAN).
- Connect serial port to a PC through null modem cable (RXD / TXD crossed over). Set terminal
emulator to 115200 8N1. - Connect Ethernet as needed.
- Connect a 12V DC power supply to the DC jack. Power supply should be able to supply at least 18W for some margin. To avoid arcing, please plug in the DC jack first, then plug the adapter into mains.
The board should now power on. All three LEDs will light during BIOS POST, then the system will try to boot. You should see BIOS messages on the serial console. Press F12 for boot device selection:
Build date: Apr 1 2014
System memory size: 2017 MB
Press F12 for boot menu.
Select boot device:
1. USB MSC Drive 8.07
2. iPXE (PCI 00:00.0)
3. Payload [setup]
4. Payload [memtest]
-
db9 is not a null cable right?? I need a RS232 ??
-
It can be. What did you order?
-
Has this ever booted pfsense sucessfully?
-
Has this ever booted pfsense sucessfully?
yes but I accidentally removed the lan interface trying to get dhcp working
http://www.canadacomputers.com/product_info.php?cPath=95_96&item_id=018521
also a db9 gender changer -
can you give me your public IP (in a pm) and plug the wan into the PUBLIC internet?
I want to see what it looks like from here if its possible.
Also, this thing has 3 ports?
What about the other port? Its not functioning?
-
Cant access My IP as I have no access to lan and Opt1 was never enabled
-
Buy a USB to mSATA adapter and get an image for pfsense for that device and size drive and image it to the msata maybe…
I'm not a serial interface loving guy.
