2.2 reboot loop (snmpd related)
-
Upon upgrade from 2.1.5 to 2.2 my APU1C was stuck in a reboot loop. After doing a fresh install things were stable and working until I went to re-enable SNMP, as soon as I did the reboot loop started again. I submitted the crash/bug report but was wondering if anyone had seen something similar?
-
Can you PM me the IP address from which the crash report was submitted? I can try to look it up. I have not observed that behavior myself on my APU.
-
I didn't see anything submitted from that IP address or anything nearby. Could it have come over IPv6 rather than IPv4?
-
Nope, no IPv6 here…
I can recreate the issue and I will get the details posted here in the next couple of hours.
-
OK, put the crash dump on the thread here (inside a "code" block if possible) and we can look it over.
Or if there is some other IP address it may have submitted from, let us know and we can check for it again.
-
Well, I have some good news…
I just tried recreating this issue and I have successfully enabled SNMP and bound it to my LAN interface and so far so good. I am going to issue a reboot to make sure a clean boot is good as well.
-
Still good after a full reboot as well…
Maybe something in the latest snapshot fixed it.
