Incomming connection issue when using openvpn

Derelict

Are there pass rules on the OpenVPN tab that also match the traffic? If so, I believe that will match first and break reply to. I usually delete all the rules on the OpenVPN tab when I use assigned interfaces.

armsby

there is only that one rule there

rules from the openvpn there is only this

rules from the lan interface that make is select the openvpn interface thise are the first rules there

| type | proto | Source | Port | Destination | Port | Gateway | Queue |
| allow | IPv4 * | 10.0.80.24 | * | ! owennet | * | VPN_VPNV4 | none |
| allow | IPv4 * | 10.0.80.24 | * | owennet | * | * | none |
| deny | IPv4 * | 10.0.80.24 | * | * | * | * | none |

Derelict

I'd ditch that rule and put it on the assigned interface's firewall rule tab instead.

armsby

I have tried that, but pfsense still select the wrong interface for reply-to

Derelict

This stuff works, man. pfSense is only doing what you're telling it to do.

Use the diagram in my sig to detail exactly what you're doing and I'll build it tonight. Please be specific.

armsby

ok using you diagram

pfsense A

connected with 2 wan, 2 openvpns

connectes in/out works ok on wan

connection works fine from lan and opt1

connections going out from opt1 host A2 is redirected to ovpnc2 works fine

connections comming in from internet ocer ovpnc2 to host A2 does not work

port 53 is configured be redirected to host but packages are comming threre but reply is sent over wan

I just created that config on my firewall as the only config there and it did not work

Derelict

You can't NAT on the openvpn tab. It has to be an assigned interface. I don't see ovpnc2 in that firewall output at all.

armsby

I have tried that today, assigned it to an interface, got teh interface up with the ip, still not possible to get traffic in only out, in comming traffic are still routed back over default route not the rule's reply-to

Derelict

post screenshots of all your rules.

armsby

ok screen shots of all my interfaces and rules comming up

WAN interface default gateway

WAN2 interface, in use if first fails

openvpn client1

nothing forwarded here works, the reply is send back over default gw

openvpn client2

same as above

DMZ

NAT

interface assignment

This is the setup I like to have working and that was working with pfsense 2 but does not work with 2.2

Derelict

Please post the rules on the OpenVPN tab.

armsby

openvpn tab

Derelict

Get rid of that. In order to have things like Reply-To working, the OpenVPN tab cannot match the traffic. I would just not put any rules on OpenVPN tab. Put them on the appropriate assigned interface instead.

Derelict

Note my first post on this thread.

doktornotor

So, what's this?

nat on $VPN from 10.0.80.0/24 to any port 500 -> 10.103.1.6/32 static-port

Your IPsec overlaps with OpenVPN. This will never work.

armsby

@Derelict:

Note my first post on this thread.

Thank you, I dont know how I missed that all the when ever I checked, that rule should of cause have a limited source address range, adding that it works perfect

, thank you again