Incomming connection issue when using openvpn
-
You can't NAT on the openvpn tab. It has to be an assigned interface. I don't see ovpnc2 in that firewall output at all.
-
I have tried that today, assigned it to an interface, got teh interface up with the ip, still not possible to get traffic in only out, in comming traffic are still routed back over default route not the rule's reply-to
-
post screenshots of all your rules.
-
ok screen shots of all my interfaces and rules comming up
WAN interface default gateway
WAN2 interface, in use if first fails
openvpn client1
nothing forwarded here works, the reply is send back over default gw
openvpn client2
same as above
DMZ
NAT
interface assignment
This is the setup I like to have working and that was working with pfsense 2 but does not work with 2.2
-
Please post the rules on the OpenVPN tab.
-
openvpn tab
-
Get rid of that. In order to have things like Reply-To working, the OpenVPN tab cannot match the traffic. I would just not put any rules on OpenVPN tab. Put them on the appropriate assigned interface instead.
-
Note my first post on this thread.
-
So, what's this?
nat on $VPN from 10.0.80.0/24 to any port 500 -> 10.103.1.6/32 static-port
Your IPsec overlaps with OpenVPN. This will never work.
-
Note my first post on this thread.
Thank you, I dont know how I missed that all the when ever I checked, that rule should of cause have a limited source address range, adding that it works perfect
, thank you again
