Mini ITX Recommendations
-
-
The bulk of the Haswell boards you'll find will NOT have working NICs. The i210 and i217 Intel NICs are not currently supported.
-
For what it's worth, I am using this as a firewall at work: http://www.amazon.com/Jetway-NF96U-525-LF-Mini-ITX-Motherboard-Onboard/dp/B008GWMIWM/
with this: http://www.amazon.com/Jetway-AD3INLAN-G-Daughterboard-Controller-motherboards/dp/B003Y3RWV0/
I can confirm that the 3x Intel daughterboard works fine with both pfsense 2.0.3 & 2.1, and the realteks were recognized when I upgraded to 2.1.
-
The bulk of the Haswell boards you'll find will NOT have working NICs. The i210 and i217 Intel NICs are not currently supported.
The Jetway NF9J Q87 says 1 x Intel I217LM PHY Gigabit LAN (iAMT 9.0) and 1 x Intel 82574L PCIE Gigabit LAN. So, then one of the NICs is unsupported.
-
I've been using pfSense for a little over a year now on an old computer I had lying around. I'd like to get a mini itx (or something similar) that will run 2.2 smoothly. I currently have a 50 meg connection at home, and will hopefully be able to upgrade to 100 meg+ within a year. Are there any recommendations? I'm good building or buying pre-built…
I was thinking about getting one of these, but with all Intel NIC (which the description states is optional). Any thoughts?
Jetway NF9N-2930 Intel Quad Core 5 x LAN Fanless Networking Appliance, 2GB, 557 https://www.amazon.com/dp/B00SX9V9DC/ref=cm_sw_r_awd_a8m3ub1EWZGYK
Thanks in advance
-Lenny
-
I have no experience with this, but do have my eye on it: Supermicro A1SRI-2558F-O. This is a quad-core Rangeley C2558 CPU. Rangeley means it supports AES-NI and QuickAssist. Quad Intel i354 NICs. Dedicated IMPI chip for out-of-band management. Available for $240+10 S/H from SuperBiiz. Obviously cost will be higher once you add ECC SO-DIMMs, storage, case and power supply.
If electrical power draw is a concern (it is for me), I'm guessing this board might idle around 15 watts with an efficient power supply. I can't find anyone on the web who's posted numbers, but there are numbers available for similar Avoton/Rangeley systems. It's been my experience that Intel CPUs in the same family tend to have the same (or very similar) idle power consumption, even if their TDPs are different. I'd wager that you can probably save a watt or two if you disable any unneeded ports, a couple cores, use one DIMM instead of two, etc. But again, this paragraph is mostly speculation, I'm just thinking out loud.
Semi-comparable systems might be the Netgate RCC-VE or Netgate RCC-DFF systems. But those have less flexibility (IMO) given the fixed RAM, and no IPMI.
-
I am running my pfsense on a gigabyte j1800-d2h mini itx and it is running fine and i have no performance/driver issues.
i just found this car wirt with an celeron 1900 ! and dual gigabyte lan (realtek)
http://www.kitguru.net/components/cpu/leo-waldock/gigabyte-j1900n-d3v-review/i think this is the best mini itx MB to run pfsense on considered the low price and low power consumption
http://www.ebay.co.uk/itm/Gigabyte-GA-J1900N-D3V-Desktop-Motherboard-Intel-Chipset-/291349323150?pt=LH_DefaultDomain_0&hash=item43d5c5dd8e -
I Currently run 2.2 on a Gigabyte J1900 and have it working well, there's a pretty long thread on this board here on pfsense forums - you might have some install issues that can be fixed with the advice in that thread.
also, if you don't need dual lan ports, the Asrock Q2900 or the Q1900TM might be good solutions:
http://www.newegg.com/Product/Product.aspx?Item=N82E16813157546
http://www.newegg.com/Product/Product.aspx?Item=N82E16813157496 -
My biggest recommendation for the j1900s is set it up and leave it alone. Don't plug in and unplug any usb drives etc or you will end up going into bios to set up boot order all the time. Other than that, its very nice.
-
ion the cheap:
-
gigabyte celeron-j 1900 itx with dual on-board realtek nics (GA-J1900N-D3V (rev. 1.x)) and 4-8gb so-dimms - max is 8gb and no ecc
-
athlon 5350 with an asus AM1I-A and a ebay intel dual nic gigabit pcie card and 4-8gb+ of regular ram (ecc works)
anything above cheap:
when you add in the cost of an i3, decent board, intel nic,etc - makes more sense to go SUPERMICRO MBD-A1SRi-2758F-O
http://www.newegg.com/Product/Product.aspx?Item=N82E16813182855&cm_re=atom_c2758--13-182-855--Product
add some ecc ram and run with it
-
-
I builded my last box (few months ago) with the Jetway NF9N with Intel Celeron N2930 and their GEN2 4XNIC Intel Daughter card. Totaled about $220
It is working very smoothly, then again my load is very low, home environment, 1 EXSi server (3 instances), 1 NAS, 1 Workstation, handful of mobiles devices.