What the Beep?
-
Bump
Anyone? Surely there must be a way to increase the beep volume.
-
Sudden urge to listen to the Pussy Cat Dolls again….
I guess I didn't notice because everything is remote from me now.
-
Beep-Beep!
I like them too, especially as I use IPMI to access my router and I can hear it from the other room.
-
Interesting, I can't say I noticed a change in volume. You're are saying this changed just with a firmware upgrade?
Steve
-
Interesting, I can't say I noticed a change in volume. You're are saying this changed just with a firmware upgrade?
Steve
Yes. In 2.1.5, and previous 2.1.x versions, it was very load. Like what I'd expect for full volume. Immediately following fresh install of 2.2, with 2.1.5 config restore, it is barely audible.
DELL Inspiron 5100 notebook
-
Making no other changes …
Boot up the old 2.1.5 and beep volume is loud as before.
Boot up the new 2.2 and beep volume is faint (barely audible).System volume control (Fn keys) have no effect with either 2.1.5 nor 2.2.
DELL Inspiron 5100
-
Try this command in the shell:
sysctl hw.snd.vpc_0db=1 -
Try this command in the shell:
sysctl hw.snd.vpc_0db=1Currently set at 45.
Change to 1 makes no difference. -
Why would you decrease it to make it louder? :o
-
Why would you decrease it to make it louder? :o
Dunno but some guy on Google said it, and everything that is on the internet is true… :P
I also tried:```
sysctl hw.syscons.bell=* -
hw.syscons.bell is a boolean (0/1 off/on).
-
The beep command operates at a lower level than the snd device. It drives the buzzer directly. I don't think hw.snd will have any effect here.
Steve
-
It could be due to the difference between the old console (syscons) and VT in some setups.
At least on my APU the sound doesn't seem to be any quieter.
-
Though we set kern.vty=sc so it should be using syscons not vt, so perhaps not.
Still could be related.
-
Where is kern.vty=sc setting? Couldn't find it.
-
It's apparently the default for us and not explicitly set
