Gateway Upload Issue
-
Hi,
I have 2 internet connections at my house and I am trying to setup pfSense in multi-wan.
Everything works but I get upload errors on bandwidth test sites like speedtest and am unable to send some emails or upload anything bigger than a few kb to a website.As a test I created a new VM in virtual box and installed pfSense only changing the below
Network IP Addresses:
ADSL Router: 192.168.10.8
Windows 7 Computer: 192.168.10.120Console
hn0 -> WAN
hn1 -> LANSet LAN IP address to 192.168.10.10
Interfaces > Wan
Uncheck "Enable Interface"System > Routing > Create Gateway
Name: ADSL
Interface: LAN
Gateway: 192.168.10.8
Monitor IP: 8.8.8.8Firewall > Rules > Lan > Edit IPv4 *
Gateway: ADSL - 192.168.10.8Now if I go to the windows 7 computer and set my default gateway to 192.168.10.8(ADSL Router) everything works but if I set the default gateway to 192.168.10.10(pfSense) and browse to a speed test site I get the correct download speed but upload hangs for about an minute and then complains about an error if I try and upload to a website I get “This webpage is not available”.
As a second test I did the same setup on Hyper-V and tested with a windows 8 computer and got the same issue. Since this is completely different hardware I’m guessing something is wrong with the way I am configuring everything.
Any ideas what I’m doing wrong?
-
Why is the ADSL router sitting on your LAN?
You are getting asymmetric routing - the client sends packets to pfSense (its default gateway). pfSense sends them across to ADSL router, which gets them to the internet. On return packets, ADSL router delivers them directly to the client, because it is on the same subnet. pfSense does not see the return traffic, states time out, seesion sops working after 30 seconds or so.You should have 3 interfaces to do this - LAN, WAN1, WAN2
-
Thanks for the reply.
There is not really any reason why i have the ADSL router on the LAN, i was just testing pfsense on my current environment.
Just out of curiosity, I was playing around with ZeroShell and it somehow routed the packets correct is there some way of configuring pfSense to "tag" the packets to return to the pfSense box?
So to fix my current issue can i just change the IP address of the ADSL router to 192.168.11.8 and set the wan on pfSense to 192.168.11.10 or do i have to physically connect the ADSL router to the WAN port and make sure it is not physical on the same network as the lan?