Issue with Broadcom fiber card
-
Hi,
I'm trying to setup pfSense firewall and cannot get a link on that card: http://www.alliedtelesis.com/p-1855.htmlI have tried both autonegotiation as well as forced speed/duplex, but no luck.
I used pfSense 2.0.2 and the latest beta version.
The status says no carrier.
I am 100% sure that card and the fiber link are working because when I boot Linux on that box I can configure that card and all is working fine.Any ideas?
Thanks
PKifconfig bge0
bge0: flags=8843 <up,broadcast,running,simplex,multicast>metric 0 mtu 1500
options=8009b <rxcsum,txcsum,vlan_mtu,vlan_hwtagging,vlan_hwcsum,linkstate>ether ec6d:72:44:4c
inet6 fe80::eecd:6dff:fe72:444c%bge0 prefixlen 64 scopeid 0x3
nd6 options=1 <performnud>media: Ethernet 1000baseSX <full-duplex>(none)
status: no carrierdmesg shows:
bge0: <allied telesis="" at-2972sx,="" asic="" rev.="" 0x009003="">mem 0xfb920000-0xfb92ffff,0xfb910000-0xfb91ffff irq 40 at device 4.0 on pci9
bge0: CHIP ID 0x00009003; ASIC REV 0x09; CHIP REV 0x90; PCI-X
miibus0: <mii bus="">on bge0
brgphy0: <bcm5714 10="" 100="" 1000basetx="" phy="">PHY 1 on miibus0
brgphy0: 1000baseSX-FDX, auto
bge0: [ITHREAD]</bcm5714></mii></allied></full-duplex></performnud></rxcsum,txcsum,vlan_mtu,vlan_hwtagging,vlan_hwcsum,linkstate></up,broadcast,running,simplex,multicast>