Need Help with NAT
-
Here is the scenario. I am trying to NAT all of our employee vpn traffic outbound to a single address. This seems to work out great for networks which are attached to pfsense but I can't get it to work for a network coming through pfsense.
For example I have no issue with an outbound NAT rule translating 10.80.0.0/16 to my LAN interface.
LAN 10.80.0.0/16 * 10.230.0.0/16 * * * NOI would like to do the same idea with another network, but this network is not a interface of pfsense. Pfsense has a static route to get back to this network.
LAN 192.168.170.0/24 * 10.230.0.0/16 * * * NOFor some reason I can't get the 192.168.170.0/24 to translate like the 10.80.0.0/16
-
That rules should make it look like traffic from that network is coming from the LAN ip address. Have you run a network trace to make sure that this is not happening? There might be a routing issue that is preventing return traffic.
-
Interface Source Source Port Destination Destination Port NAT Address NAT Port Static Port Description
Where is your nat address in those rules?
If you see above I posted the headings from the nat rules, I don't do any natting on my lan side - but only from lan to wan. But don't you still need a NAT address to use? In my drop down you can pick the interface address or setup a different IP, yours is just showing *?