Outbound Manual NAT not applying
-
Hi guys, I have had some Outbound NAT rules setup and working for a while now. I have just added an additional rule so that all outbound traffic from a specific Network 192.168.15.0/24 uses a specific IP Address of 101.98.12.100. This is a subnet I want to use for all WIFI and BYOD access so it shows as coming from a different IP mas our main corporate traffic.
The 2 rules to apply the same sort of thing for our mail server 101.98.12.97 is working fine. All other web traffic shows as from 101.98.12.98 which is th ebottom rules you can see in the screenshot below.
Any ideas why this new rule for 101.98.12.100 is not working?
The addresses are set as VIPs:
Also the NIC is set to be 192.168.15.5/24.
Thanks for your help!
-
It's on the wrong interface. Egress interface, which looks like it should be WAN.
-
Good spot, thanks I totally missed that. I fixed it but it doesn't seem to of changed anything. Traffic from my mobile which is on WIFI using the IP 192.168.15.105 should be showing a WAN IP of 101.98.12.100 but it is still showing 101.98.12.98 so it is getting to the last outbouund NAT rule. Any other ideas?
-
Did you reboot after changing this?
-
haha IT 101. Yes I did. Still no change.
-
Anyone else got any ideas? Cheers.
-
Post the same screenshots again.
-
Sure here you go:
And here is the ip address my mobile is using when on the BYOD network, still 101.98.12.98:
-
It's still on the wrong interface, Holmes. OUTBOUND NAT goes on the OUTBOUND interface. Change that BYOD to WAN.
Change the VIP too. It should also be on WAN.
-
Ahhh! Right, thanks mate that fixed it. I appreciate the help.
Awesome!