Port forwarding not working after upgrade to 2.5

[kireol]

I'm running a Watchguard x750e that I updated to pfsense 2.2.5-RELEASE

I had some rules that worked before for port forwarding.

One in particular is for plex. (none of my rules are working yet)

I went through my nat and deleted everything for the old plex forwarding and readded.  That didn't help.

I'm not sure what I'm doing wrong.

For the x750e, I'm only using 2 NICs right now.  1 for wan, 1 for lan.

My plex box sits on the lan.

From within my lan, I can use plex from a browser, so I know that parts working.

But, the hole that poked through doesnt seem to be working.

Here's what I have.

Under firewall->nat

1 Rule
Interface:wan
protocol:tcp/udp (also tried just tcp)
Destination port range: 32400
Redirect target IP: 192.168.1.71 (that's the port of my server on the lan)
Nat reflection: use system default
Filter rule association: Rule NAT plex32400

Under Firewall->Rules

1 Rule
Action:Pass
Interface:wan
TCP/IP Version: ipv4
Protocol: tcpudp
Destination: Single host or alias 192.168.1.71 / 31
Destination port range: 32400 32400

From my server:
The following shows the ip is correct, the server can get out to the interwebs, and the port is correct.

ifconfig -a | grep 192
          inet addr:192.168.1.71

ping pfsense.org
PING pfsense.org (208.123.73.69) 56(84) bytes of data.
64 bytes from www2.atx.pfmechanics.com (208.123.73.69): icmp_seq=1 ttl=44 time=69.1 ms

lsof -i :32400
COMMAND  PID USER  FD  TYPE DEVICE SIZE/OFF NODE NAME
Plex    2077 plex  54u  IPv4  20779      0t0  TCP *:32400 (LISTEN)

What did I do wrong?

[kireol]

Resolved.

When I updated pfsense, my ISP gave my router a new IP.  My internet box had NAT to the old ip.  Updated the ip, and it's working now.

[Derelict]

Try using Destination: WAN address instead.

[steve72]

I had ipv6 enabled and all my rules didn't work after the upgrade.

Try and enable " Prefer to use IPv4 even if IPv6 is available"