Cannot Configure Multiple IPs
-
Hi everyone,
Ok I am an IT Support tech so have a pretty good hands on knowledge on fixing things and setting up networks etc. However I have never had experience setting up an advanced firewall etc. I have done a lot of searching and there is a lot of posts of people requesting the same/similar to what I want, however I cannot figure it out.
What I have:
Fiber NTU
PFSense on Dell 1RU server- 6 Physical NICs
Internode as my ISP with a static IP + a /29 subnet
What I want:
Configure PFSense to port forward the desired IPs that I want to which ever server I want. I do not want 1:1 NAT.
I have tried for a few days following several suggestions and tips from this forum and others. However I think some of the instructions might be lacking or assuming knowledge/other settings to have already been set. I wont list everything that I have tried and I would like help to set this up from scratch. If need be I can pay for more personal assistance.
I will include all actual information so there is no confusion.
WAN Interface
Internode (ISP)
PPPoE
Gets assigned Static IP:
59.167.254.53/29 Subnet
59.167.78.8LAN Interface
192.168.1.1
255.255.255.0LAN Interface
192.168.0.1
255.255.255.0At this stage I want to know how to forward ports from an IP in the /29 subnet to an IP on either of the LANs. Please assume I have no knowledge and try to explain the steps involved not just "add virtual IP".
Thanks for reading and any assistance,
Dave - 6 Physical NICs
-
NVM
Turns out ISP had routed an IP range that was already in use.