IPSEC Site-to-Site show me connected but I can't access
-
Hey there
I'm running IPSEC site-to-site both are running pfsense 2.2.5-RELEASE, my problem start when i went to Status>IPSEC and i can see that tunnel its works but when i try to run ping the address ip of other site, it doesn't work, after i closed the connection between sites and connect again the communication back to work.
Could you give any tip about that ?
Sincerely,
Renato
-
What do you have in your IPsec logs on both sides when it's not working? Do both sides show as up under Status>IPsec?
-
Did you configure the appropriate firewall rules?
-
Thank you for your attention…yes both rules are permitted, and after the communication stopped show as up under Status>IPsec
-
Yes I did buddy
-
And your IPsec logs show what at the time?
-
So in my case doesn't show me any relevant information :(