[2.2] Mobile clients not connecting anymore

dharrigan

@ermal:

Do you see on the logs anything related to identity?

This seems like android is not sending the proper identity as configured hence it works when left blank because it sends its ip.

This is the full log taken during my tests.

Given this, isn't it better to work in main mode? Or does removing the identifier creates a security problem? thanks
[tough this is not yet an acceptable solution to me, I cannot connect using Ubuntu's network manager strongswan]

Hi,

Unfortunately, it seems that if you run main mode, then iOS clients fail to connect. It has to be aggressive for them!

-=david=-

eri--

It means this will be fixed when support for multiple mobile sections is merged in.

dharrigan

rocking and rolling!!!! :-)

mucho gracious! :-)

-=david=-

dharrigan

Hi Again,

would you happen to have the ticket/issue number for the new code to be merged in? I would like to add myself as a watcher :-)

-=david=-

maxxer

@ermal:

It means this will be fixed when support for multiple mobile sections is merged in.

what?

alessandroa

I have the same problem after upgrade to 2.2 versione. Android client going in time-out, Shrew client work (but I'd must change local network in 0.0.0.0/0 in phase 2).

The solution for me was change to main mode, so in pfSense I changed the negotiantion mode in phase 1, in the Shrew I changed the configuration to main mode, in Android clients I can't specify this mode, but if I leave blank the IPsec identifier, the client change authenticaion in main mode.

I don't know if this is a bug or what, I'll test better next time before upgrade ;-) (I've another problem with php version in another installation).

Thank you

Bluejay

@maxxer:

I had to do two changes:

on the server set IPSec mobile to main mode

on the Android client remove the IPSec identifier field (leave blank)

To confirm, I had the same problem with my Android clients, and these two steps fixed it. I am now able to connect to my VPN from both of my Android 5.0 devices.

w0w

For the android clients there is strongswan app in market and it works, but quite differently, for me it does not route all traffic to VPN, only LAN subnet traffic.
Anyway I did not have any luck with empty ID field on 4.1.2 android.

HaburGate

Empty ID field didn't work for us either, sadly.

newmember

I deleted my 'Mobile Client' under Tunnels, then went to 'Mobile Clients' tab and saw that "Create Phase 1" option was available.
I re-created Phase and Phase 2 and the vpn worked again.

Cheers

VPN: IPsec: Edit Phase 1: Mobile Client

Key Exchange version V1
Internet Protocol Ipv4
Interface WAN
Description Mobile Client

Authentication method Mutual PSK
Negotiation mode Aggressive
My identifier My IP Address

Encryption algorithm AES 256
Hash algorithm SHA1
DH key group 2
Lifetime 28800

NAT Traversal Force
Dead Peer Detection Enable / 10 / 5

VPN: IPsec: Edit Phase 2: Mobile Client

Local Network DMZ (mine is DMZ but yours might be LAN)
Protocol ESP

Encryption algorithms AES 256 (only)
Hash algorithms SHA1
PFS key group 2
Lifetime 3600