Limiter on WAN rule
-
Hey!
I have a WAN rule that is part of a NAT redirect. The rule basically allows TCP 7001 to an internal IP address. I have someone using it to access some files, but at the same rate I don't want them saturating my upstream pipe (it's not that big.) So I created two limiters at 500Kb each and applied them in each direction for the rule. But when I do this the rule allowing access via that NAT is then not followed by PfSense. If I remove the rate limiters from the rule (e.g. setting it to none) then the rule works again.
Why I do the same thing to a rule on the LAN, it seems to work just fine.
Did I miss something and Limiters are not allowed on WAN interfaces or could I possibly have done something wrong? Normally I just apply a limited to a firewall rule and then it applies to that rule and uses the limiter as a queue depending on how it is masked in the limiter setup. Right now it is set to 0.0.0.0 which should be anything. Thanks!
-
https://redmine.pfsense.org/issues/4326
-
thanks! Seems like this has been going on for a while too. Sad.
I found the same issue could be replicated if I setup an in/out queue for the interface. As soon as it filled no new traffic was passed from the WAN to the LAN.
-
FYI- This is no longer a problem on 2.4.