Pfsense 1.2 RC3 install woes (wan problem)
-
Hi Guys,
It's been a while since I got my hands wet with pfsense and I thought it would be a walk in the park after a year of absence using it but apparently not, I'm bumping into some road blocks that's been difficult for me to get over. Currently we are using a proprietary firewall appliance that already reached EOL vendor support and we would like to replace it by implementing pfsense in all of our offices. I'm using the 1.2 RC3 release in my HP Compaq D220 MT (3 nics) and our isp provided us with 124.107.xx.xx/29 ip block. I was amazed that the WAN interface got an ip address from the modem, apparently it's also a dhcp server, I also configured the LAN and DMZ interface. When the WAN interface is using a dhcp assigned public ip address from the modem/gateway, there's no problem, LAN clients have internet connection but when I set the WAN interface to static ip address, problems set in. LAN clients don't have internet connection, I also checked if the switch where the modem/gateway and WAN interface is connected is the culprit but it isn't because when I connected a windows client and assigned it a public ip, it can connect to the internet just fine. I'm totally clueless as to what's causing the problem, any of you guys experienced this? What would be the workaround if any?
TIA
-
Did you set a DNS servers manually after you've set the static public IP?
-
When you setup the WAN interface with Static IP, you need to put in the right CIDR Mask Bits.
For example: your WAN IP is 10.10.1.1 and the Subnet Mask 255.255.255.0 then your CIDR Mask Bits is 24.
-
Did you set a DNS servers manually after you've set the static public IP?
Hi GruensFroeschli,
Yes, I did set the DNS servers manually after changing the IP address to static, I even ran the setup wizard to no avail, still have the same problem. One weird thing I also noticed is that when I installed the 3rd nic (I'm still using the DHCP assigned public IP during first install) after a restart, the console generated "No Route to host messages" and I have no internet connection anymore. What do you think is causing this?
TIA,
Jan
-
When you setup the WAN interface with Static IP, you need to put in the right CIDR Mask Bits.
For example: your WAN IP is 10.10.1.1 and the Subnet Mask 255.255.255.0 then your CIDR Mask Bits is 24.
My public IP is 124.107.xx.xx and the subnet mask is 255.255.255.248, I think at first I've used the /32 because it's a single IP, is this correct? I also think that I tried using /29 as CIDR and also did not work, I'm not sure though if I really did the latter.
-
No, if your subnet mask is 255.255.255.248 then you should use /29. You should also check the Gateway and DNS for the right IP setting.
-
No, if your subnet mask is 255.255.255.248 then you should use /29. You should also check the Gateway and DNS for the right IP setting.
My mindset was I'm configuring the NAT that is why the /32 netmask, anyways, it's now working when set to /29. So simple yet overlooked. Thanks.