Static route seem not work

doktornotor

Perhaps you could produce some network diagram. Cannot make sense of it.

monchito

Hi doktornotor,

Here is the diagram.

Hope it helps

Also, i check the routing logs (/var/log/rounting), i get this error:

Dec  8 19:34:53 pfSense radvd[26269]: version 1.9.1 started
Dec  8 19:34:53 pfSense radvd[26269]: no auto-selected prefix on interface em1, disabling advertisements
Dec  8 19:36:48 pfSense radvd[26604]: Exiting, sigterm or sigint received.
Dec  8 19:36:48 pfSense radvd[26604]: sending stop adverts
Dec  8 19:36:48 pfSense radvd[26604]: removing /var/run/radvd.pid

Pfsense version: 2.3.2-RELEASE-p1 (amd64)

Thanks!

monchito

I think i got this.

In pfsense firewall, on the WAN interface (192.168.1.2):

It been configured on an interface IPv4 upstream gateway: GW1 (192.168.1.1) so i change that for "none"

I have to test on production, but i what do you think?

Thanks!

doktornotor

I think your network design is completely broken. You cannot have WAN and LAN on the same subnet.

monchito

I agree, this was already configured, i don't designed the network. But in this case "WAN" is just a name. Of course i like to change it to "lan2" for example.

Thanks for reply.

doktornotor

No. Let me try again. You cannot have ANY two network interfaces on the same subnet.

monchito

Hi doktornotor, this network is already on production with another technology, i agree that this is not the best solution, neither a good solution, but I have this reality and nobody wants to authorize the change me for the cost and the impact asociated.

I already saw something like this in others fabricant "overlapping subnets" (like that they calling). But, I'm new to Pfsense, when you said "can not" it's really "can not" in pfsense, or is it "should not"?

Thanks again for your reply.

doktornotor

Let me try for the last time. You ABSOLUTELY CANNOT have two interfaces on the same subnet. Only one will have link route. Period. Redo your network. Will not ever work.

kpa

Seconded, your set up is an invalid one. The only way to have the same subnet on two or more interfaces at the same time is to use bridging, if you don't want to take that route you have to redo your set up with a different subnet on pfSense's LAN.

johnpoz

Not seeing where your lan network is called out.. is it also 192.168.1/24?? Or some other sub of 192.168.1 that overlaps with 192.168.1/24 - if so then NO you can not do it that way..

You for sure could have multiple routes to different IPs on your wan that is your transit network.. But you can not expect it to work if your lan side clients are on 192.168.1/? And you want them to go to the internet or this other 10.200 network