APU.1D4 with 2.3.4 asks for interface setup in every reboot
-
Pretty much what the title says:
After every reboot, cannot connec to the unit. When connected via serial, shows that asks again for interface assignment.
Any solution?
Best regards
Kostas
-
I've loaded 2.3.4 on one with no trouble- full install to either MSata or SD.
Are you using full or nano? What do your interfaces show? I'd save the config and re-install. See if it happens with the default config before you restore your saved config. -
Had no issue for days, testing the unit in our office. Took it to the contents premises and during setup it start behaving like this, and continues. I have 2.3.4 in an msata (Kingston 60 GB).
Do you suggest to reinstall from scratch?
Best regards
Kostas
-
Thank you,
As mentioned, it use to work fine for months. The only difference was I installed a USB to Ethernet adapter (Anker 10-100-100, Realtek chip), and then the issues started, but the adapter worked OK, no errors in statistics.
I have tried to reset to factory, and right after the initial configuration, I rebooted, same issue.
Best regards
Kostas
-
I removed the USB adapter and run the assignment again. Now the configuration survives the reboots.
Ι need the USB, so I will try with another adapter.
Best regards
Kostas
-
Tried with another adapter, this time USB2 (the other was USB3). Now the system survives reboots.
I will check and let you know.
Best regards
Kostas
