Allow add more ASN in openbgpd

yon

now only openbgpd use an my side Autonomous Systems (AS) Number, why it is can't add more ASN? i need add more my ASN how do it?
???

jimp

Make a manual configuration by hand. Assuming OpenBGPD supports that.

Normally you would not have more than one AS. The AS is you, and all your networks would be a part of that AS.

Not even the FRR package will currently handle more than one BGP AS. It can with a manual configuration, but you'd have to craft that by hand.

johnpoz

With Jimp here - normally if you acquire more public IP space you just add it to your current ASN..

yon

@jimp:

Make a manual configuration by hand. Assuming OpenBGPD supports that.

Normally you would not have more than one AS. The AS is you, and all your networks would be a part of that AS.

Not even the FRR package will currently handle more than one BGP AS. It can with a manual configuration, but you'd have to craft that by hand.

There are a variety of situations that may exist，for example

1. I use private and public ASN EC: ｉ am using dn42 network and pubilc network etc.
2. I have multiple different areas ASN ec: RIPE APNIC AND ARIN
3. I have to replace friends or client ASN announce
Use hand is not easy. The current use of manual and interface conflict

yon

I asked my friends that many of the systems they used supported multiple ASNs. such routeOS and bird

and why the openbgpd cant righ show like "4242423159" asn? now it is show "64734.14531"

FRR package can't normal work now. 0.0.1 ipv6 not work. 0.0.2 all not work.

and i can't add Local address X in FRR

where are the FRR config file?

johnpoz

To be honest I think such a configuration is beyond what pfsense designed for.. Normally you would do this in multiple VRFs which sure you could do on say a bigger cisco router.

If manual configuration is above your skill set.. Why not break out different pfsense boxes for your different connections where you need to use different ASNs and have multiple connections, etc. This will for sure simplify the connectivity..

doktornotor

Oh noes, not this again… OpenBGPD supports raw config. So does FRR. You cannot mix GUI with raw config. Plus these packages' GUIs are designed for normal, sane use. Looking at your other threads, your use is anything but sane.

yon

I think Pfsense should be more professional. i know BGP fans not using pfsense, but i use pfsense years hope it is better and more professional for easy use.
I think it is easier for a professional to use it as a goal. :)

yon

the openbgpd Status how show the 32bit ASN to asplain? In accordance with the provisions should be displayed as decimal

https://www.ietf.org/rfc/rfc5396.txt
https://submit.apnic.net/cgi-bin/convert-asn.pl