SG-3100: SSD S.M.A.R.T. status not displayed in widget
-
…and the drive tools in Diagnostics don't work either. Of course, smartctl does not work in the command line either.
Is there another command to try or is SMART status in the SG-3100?
(the ssd I manually installed does support smart and it is enabled as shown in camcontrol)
camcontrol identify ada0 pass0: <ts32gmts800 p1225ce="">ACS-2 ATA SATA 3.x device pass0: 600.000MB/s transfers (SATA 3.x, UDMA6, PIO 1024bytes) protocol ATA/ATAPI-9 SATA 3.x device model TS32GMTS800 firmware revision P1225CE serial number E0XXXXXXXX cylinders 16383 heads 16 sectors/track 63 sector size logical 512, physical 512, offset 0 LBA supported 62533296 sectors LBA48 supported 62533296 sectors PIO supported PIO4 DMA supported WDMA2 UDMA6 media RPM non-rotating Feature Support Enabled Value Vendor read ahead yes yes write cache yes yes flush cache yes yes overlap no Tagged Command Queuing (TCQ) no no Native Command Queuing (NCQ) yes 32 tags NCQ Queue Management no NCQ Streaming no Receive & Send FPDMA Queued no SMART yes yes microcode download yes yes security yes no power management yes yes advanced power management no no automatic acoustic management yes no 0/0x00 0/0x00 media status notification no no power-up in Standby no no write-read-verify no no unload no no general purpose logging yes yes free-fall no no Data Set Management (DSM/TRIM) yes DSM - max 512byte blocks yes 8 DSM - deterministic read yes zeroed Host Protected Area (HPA) yes no 62533296/62533296 HPA - Security no</ts32gmts800> -
So is your drive even listed when you go to
Diagnostics > SMART Status
In the drop down?
-
smartmontools was disabled for ARM back in our early development for ARM (~Aug 2016). It may not have built at the time, or it may have been omitted because our first target platform was SG-1000 and it didn't have a disk it could be used with.
Either way, it builds now and makes sense for SG-3100 and other newer platforms that can have SSDs so we'll enable it again now, should be in builds soonish.
-
Thanks @jimp.
(FYI, the drive is listed in Diagnostics->SMART Status, but none of the options produce any output.)
-
I don't have an SSD in my 3100 but the smartctl binary is there now, so it should be OK on 2.4.3.
If you are comfortable running a snapshot, you can upgrade to a 2.4.3 snapshot now and test. If not, 2.4.3 should be out in a couple weeks.
