Network Jumps Pf Sense with OpenVpn

AvelardoJC

Hello dears,

I thank you for guiding me a bit about a problem I have, the subject is the following:

I made a vpn of 3 sites to a remote office using openvpn as a tool, the network segments are like this:

192.175.0.0/24 - PF Sense Central
192.175.4.0/24 - PF Sense site 1
192.175.5.0/24 - PF Sense site 2
192.175.6.0/24 - PF Sense site 3

Each site towards the central PF Sense has communication and from the central to any site as well, my doubt is there is some configuration that allows me to make a jump between the segments?

For example, ping 192.175.4.1 to 192.175.5.1 and respond

The vpn is by peer to peer (shared key)

heper

sure its all possible, you only needs some routes

….
but you are using public address space for you lans - it'll cause trouble & is bad practise

AvelardoJC

Hi Heper,

Not really, I'm using other segments, just to illustrate the idea, how can I make that configuration? Can you help me with a tutorial?

Thanks for your answer! :)

Derelict

If you are using private RFC1918 space, obfuscating the actual addresses does nothing but confuse matters and make it harder to help you.

AvelardoJC

I understand Derelict, I'm sorry, I use the 10.0.0.0 segments, I just wish I knew how to route the traffics mentioned above, how could I do it through the vpn master? :(

Thanks a lot!

KOM

Maybe if you posted your issue in the actual support forum for OpenVPN, you might get better answers. This isn't a support forum.

AvelardoJC

Thanks KOM, I'm going to post the topic in that forum.

Regards,