No access to OPT1 from any interface
-
I am having issues getting Opt1 interface to work properly. I have setup the Rules (listed below) to allow access in and out of that interface from the LAN and VPN interfaces. I go to Diagnostics > Ping and try to ping something, Opt1 is the only interface that I am able to ping from and get a response. This firewall is at another location and I am using the VPN to access the LAN network without issues. If I ping from the LAN net to Opt1 network, I get nothing. If I ping from VPN to OPT1, I get nothing. OPT1 does not seem to have access to WAN (Internet) interface either.
I have looked at this over the last several days, googled and tried everything I can find and still can not seem to get anywhere. What am I missing?
Rules:
OPT1
IPv4 * * * * * * none Default allow OPT1 to any ruleOpenVPN
IPv4 * * * * * * none OpenVPN VPN wizardLAN
IPv4 * LAN net * * * * none Default allow LAN to any ruleNAT Outbound is Manual
-
Hi,
When you change/add/remove firewall rules on an interface, it should work right away.
But : when you work with interfaces, I advise you to restart the VPN.Btw : the openvpn firewall rules accept ICMP traffic ?
Because you are working over VPN, I advise you to lower the risk to be locked out : open temporary a ssh - or even GUI - access on WAN, so you can login whatever happens. Then restart VPN. When all is ok, remove these entries.
-
@gertjan said in No access to OPT1 from any interface:
When you change/add/remove firewall rules on an interface, it should work right away.
Don't forget about existing states.. You may need to kill any states that were allowing the traffic you are now wanting to block.
If you can ping the opt1 interface IP from lan but can not ping stuff on the opt1 network - you sure its not their firewall on whatever it is your pinging. Also are they using opt1 IP of pfsense as their gateway to get back to you. I would sniff on the op1 interface and validate you send the traffic out to whatever it is your trying to ping.. If you see pfsense send it on, and get no answer that screams firewall on the device.
-
So what IS working here?
Do you have DHCP enabled on OPT1? Are clients pulling a lease from it?
With outbound NAT in manu7al mode you will have to add outbound NAT rules for the new OPT1 subnet.
Do you see any alerts in the GUI? It may be failing to load the new ruleset correctly. You should still be able to ping from LAN to OPT1 though even without any new rules.
Steve