Is it possible to install pfsense on fortiwifi60b

stephenw10

Can we see a photo?

provels

@firefox You can Google FWF 60B, but if it doesn't have a CF slot, I doubt you would have room to install pfSense. If no one else in the forums has tried it, you're pretty much on your own. Also, just because it has a PCMCIA slot, that doesn't mean it will react as a PC might. More likely, it's proprietary to Fortinet accessories. Could be for a modem only for out-of-band management, like my old Nokia ip530 dinosaur. Maybe someone has installed DD-WRT or Tomato on one of these if you want to experiment and even then it may route and firewall, but the wireless might not be supported. I'd probably just run it as is with the latest firmware you can get from Fortinet. It would be better optimized for the lightweight hardware. As I said ealier from my own experience with similar hardware, even with the latest 32-bit pfSense, performance is pretty poor.

stephenw10

Info appears to be from here: https://forum.fortinet.com/tm.aspx?m=76778

Or here maybe: https://forum.fortinet.com/tm.aspx?m=100451
Though that specifically lists a 64MB CF card so perhaps this is different hardware.

Steve

provels

Here's the inside of a FortiGATE 60B, possibly similar.
https://www.youtube.com/watch?v=jTeQZZyaPXI
(Bring your Dramamine...)

Perhaps it has embedded 64MB flash?

stephenw10

Maybe. In which case there's almost no chance of running pfSense on it. Unless maybe you could boot from CF card in the PCMCIA slot. Booting from PCMCIA is not common though. Or maybe from USB.

Steve

provels

@stephenw10 Be too slow anyway. On the pfSense Dashboard page, mine runs 100% CPU just displaying the graphs... Proof of concept, fine, otherwise of no real use.

stephenw10

Yeah, it would be interesting for the sake of a challenge but of little practical purpose.
Still I like a challenge.

Steve

firefox

In connection with my question, how did you find the information about the router?
My question was general not specific to Fortinet
Because I was looking for information about Check Point's router about its hardware

So I asked

As for the fortinet, I already got the answer and also the checkpoint
I'll wait until I get some hardware to fit

stephenw10
Unable to upload image of the checkpoint router (1.5 MB)

How to make a quote in the new interface?

provels

@firefox said in [Is it possible to install pfsense on fortiwifi60b]
[How to make a quote in the new interface?]
On the right, where it says "Quote"... ==>

stephenw10

There is no single site that lists this stuff, you just have to search for likely terms.

Anything out there someone has probably already looked into so might be listed on, for example, openwrt or dd-wrt HCLs. The openwrt forum recently crashed badly and much info was lost.

deviwiki is a good site for a lot of stuff. But in the fortigate case is was listed on their own forum.

If the image is too large you could resize it or upload it to some image hosting site and link to that.

Steve

firefox

here is the image of checkpoint router

0_1529114684652_Screenshot from 2018-06-15 16-291-15.jpg

stephenw10

Nothing too exciting to see there. Very unlikely you could ever get pfSense running on there. It's not x86 and probably doesn't have enough RAM to operate usefully anyway.
If you want to experiment with it I'd look at openwrt/LEDE as a suitable target OS.

Steve